Single-tuned passive filter (STPF) for mitigating harmonic in a 3-phase power system-Reference-Cited by-同舟云学术

Single-tuned passive filter (STPF) for mitigating harmonic in a 3-phase power system

Published:2023-01-12 Issue: Volume: Page:
ISSN:
Container-title:
language:
Short-container-title:

Author:

Ishaya Meshack Magaji¹,Adegboye Oluwatayomi Rereloluwa²,Agyekum Ephraim Bonah³,Elnaggar Mohamed F.⁴,Kamel Salah⁵

Affiliation:

1. Cyprus International University

2. European University of Lefke

3. Ural Federal University Named after the First President of Russia Boris

4. Prince Sattam Bin Abdulaziz University

5. Aswan University

Abstract

Abstract Harmonics constitutes multiple integrals of the fundamental frequency found in power systems or electric circuitry systems, are primarily caused by non-linear loads that draw current intermittently or have an impedance that changes each cycle of the AC voltage. This can lead to overheating of the system, loss of original waveform, and damage to equipment or system leading to extra expense economically to the consumer. Since harmonics cause distortion in the system and cannot be eliminated from the system, various methods of mitigating to an acceptable level are introduced, use of filters is one of these methods. An STPF adjusted to the 5th, 7th, 11th, 13th, 17th, and 19th harmonic order was employed in this paper in a power system and analyzed. Data was measured on the point of common coupling (PCC) panel using the power quality analyzer tool, and the system was designed on MATLAB/Simulink environment without the filter applied readings were made, and after the STPF was added, both were compared to the IEE 519-1992 standard for which the STPF totally mitigated the harmonics in the system within the standard required.

Publisher

Research Square Platform LLC

Reference21 articles.

1. M. F. Alves and T. N. Ribeiro, “Voltage sag: an overview of IEC and IEEE standards and application criteria,” in 1999 IEEE Transmission and Distribution Conference (Cat. No. 99CH36333), 1999, vol. 2, pp. 585–589.

2. R. C. Dugan, M. F. Mc Granaghan, S. Santoso, and H. W. Beaty, “Electric power systems quality.” mcgraw-Hill, 2004.

3. M. H. Bollen, “Understanding power quality problems,” in Voltage sags and Interruptions, IEEE press Piscataway, NJ, USA, 2000.

4. A. De Almeida, L. Moreira, and J. Delgado, “Power quality problems and new solutions,” in International conference on renewable energies and power quality, 2003, vol. 3, pp. 1–45.

5. Measuring electric power quality: Problems and perspectives;Ferrero A;Measurement,2008