Fabrication of polycrystalline cubic boron nitride composites under high pressure-Reference-Cited by-同舟云学术

Fabrication of polycrystalline cubic boron nitride composites under high pressure

Published:2023 Issue:2 Volume:17 Page:157-163
ISSN:1820-6131
Container-title:Processing and Application of Ceramics
language:en
Short-container-title:PAC

Author:

Mo Peicheng¹,Chen Jiarong¹,Chen Chao¹,Qin Haiqing¹,Lin Feng¹

Affiliation:

1. China Nonferrous Metal(Guilin) Geology and Mining Co. Ltd, Guilin, Guangxi, China + Guangxi Key Laboratory of superhard material, Guilin, Guangxi, China + National Engineering Research Center for Special Mineral Material, Guilin, Guangxi, China

Abstract

The PCBN (polycrystalline cubic boron nitride) composites were synthesized by mixing cubic boron nitride micropowders with Ti and Al micropowders at a certain mass ratio under high temperature and ultra-high pressure conditions. Phase composition and microstructure of the samples were analysed by X-ray diffraction and scanning electron microscopy. The effects of sintering temperature on the mechanical properties and microstructure of the PCBN ceramics were investigated. It was shown that BN, AlN, TiN and TiB2 phases coexist in the PCBN ceramics fabricated at ultra-high pressure (5.5GPa) and high temperature (1400-1500?C). With the increase of sintering temperature, pores and gaps inside the PCBN composites gradually disappeared and densified structure was formed. The best comprehensive mechanical properties of the PCBN composites were obtained at 1500 ?C with a flexural strength of 1009MPa and microhardness of 35.8GPa.

Publisher

National Library of Serbia

Subject

Ceramics and Composites

Reference23 articles.

1. P.C. Mo, J.R. Chen, Z. Zhang, C. Chen, X.Y. Pan, L.Y. Xiao, F. Lin, “The effect of CBN volume fraction on the performance of PCBN composite”, Int. J. Refract. Met. Hard Mater., 100 (2021) 105643.

2. Q.H. Li, C. Pan, Y.X. Jiao, K.X. Hu, “Research on PCBN tool dry cutting GCr15”, Machines, 6 (2018) 28-31.

3. M. Ociepa, M. Jenek, E. Feldshtein, K. Leksycki, “The phonomenon of material side flow during finish turning of EN X153CrMoV12 hardened steel with tools based on polycrystalline cubic boron nitride”, J. Superhard Mater., 41 (2019) 265-271.

4. J.A. Arsecularatne, L.C. Zhang, C. Montross, “Wear and tool life of tungsten carbide, PCBN and PCD cutting tools”, Int. J. Mach. Tool Manufac., 45 (2006) 482-491.

5. L. Rebecka, L. Filip, P. Henrik, M. Rachid, S.J. Eric, “Bushlya Volodymyr performance and wear mechanisms of PCD and PCBN cutting tools during machining titanium alloy Ti6Al4V”, Wear, 454 (2020) 203329.