Comparison of the Surface Properties of 3D-printed Permanent Restorative Resins and Resin-based CAD/CAM Blocks

Abstract

SUMMARY Objective This study aimed to investigate the surface roughness, microhardness, and color changes of resin-based computer-aided design/computer-aided manufacturing (CAD/CAM) blocks and 3D-printed permanent resins in different beverages. Methods and Materials Resin-based CAD/CAM blocks (Cerasmart 270 and Grandio Blocs) and 3D-printed permanent restorative resins (Crowntec and Permanent Crown) were used in this study. A total of 96 specimens were prepared from CAD/CAM blocks and 3D-printed permanent resins. The initial surface roughness, microhardness, and shade value of the specimens were measured. Then, the specimens prepared from each material were divided into three subgroups (n=8) and immersed in tea, coffee, and distilled water for 30 days. After the specimens were immersed in the beverages, the surface roughness, microhardness, and tone values were measured again. The data were statistically analyzed using a two-way analysis of variance test (p<0.05). Results No statistically significant difference was found in the surface roughness values of the resin-based CAD/CAM blocks and 3D-printed resins (p<0.05). Resin-based CAD/CAM blocks showed statistically significantly higher microhardness than 3D-printed permanent resins (p<0.05). Although the color changes in 3D-printed resins in tea and coffee were similar to those in resin-based CAD/CAM blocks on the first and seventh days, more color changes appeared in the 3D-printed resins after 30 days. The surface roughness and microhardness values of the specimens submerged in tea, coffee, and distilled water showed no statistically significant changes (p<0.05). Conclusions Although the surface roughness of 3D-printed permanent resins was similar to that of resin-based CAD/CAM blocks, they had a lower microhardness value. Moreover, 3D-printed permanent resins showed more color changes in tea and coffee.