Effectiveness of Different Mechanical Methods on Dentin Caries Removal: Micro-CT and Digital Image Evaluation

Abstract

SUMMARY Purpose To determine the caries removal effectiveness (CRE) and minimal invasive potential (MIP) of caries excavation methods using digital imaging and microtomography analyses. Methods Twelve human molars with occlusal caries lesions in dentin were randomly divided into three groups (carbide bur, exacavator, and polymer bur). They were sectioned mesiodistally, and standardized digital and computed microtomography x-ray (micro-CT) images were taken from each section before and after caries excavation. On each image, initial carious dentin (IC), prepared cavity (PC), and residual caries (RC) were defined according to visual criteria using ImageJ software. CRE was determined based on the RC/IC ratio, whereas MIP was determined by the PC/IC ratio. Data were analyzed using one-way analysis of variance and Student t-test or with Kruskal-Wallis and Student-Newman-Keuls test. The level of significance was set at 0.05. Results For both digital image and micro-CT analysis, the carbide bur showed higher CRE values than the excavator (p=0.0063 and p=0.0263, respectively) and the polymer bur (p=0.0028 and p=0.0005, respectively). The latter two presented similar results (p>0.05). Regarding MIP, for the digital image analysis, the polymer bur was different from the carbide bur (p=0.0030) but was not different from that of the excavator (p=0.1240). For micro-CT analysis, the MIP values of all the groups were significantly different, and the polymer bur was the most conservative method (p<0.05). Conclusions The carbide bur was the most effective method for caries removal but was not completely conservative. The polymer bur and excavator presented low invasive potential but were not able to remove all of the carious dentin.