Fast Prediction of Injection Pressure and Minimal Front Temperature for Injection Moulding-Reference-Cited by-同舟云学术

Fast Prediction of Injection Pressure and Minimal Front Temperature for Injection Moulding

Published:2011-03-01 Issue:1 Volume:26 Page:21-29
ISSN:2195-8602
Container-title:International Polymer Processing
language:en
Short-container-title:

Author:

Zhao P.¹,Fu J.¹,Zhou H.²,Yan B.²

Affiliation:

1. State Key Laboratory of Fluid Power Transmission and Control, Zhejiang University, Hangzhou, PRC

2. State Key Laboratory of Material Processing and Die & Mould Technology, Huazhong University of Science and Technology, Wuhan, PRC

Abstract

Abstract Fast prediction of injection pressure and minimal front temperature can usually be used to optimize the process parameters for injection moulding. In this paper, a fast strip analysis (FSA) model was presented on the basis of a geometric approximation method, which simplifies an original part to a rectangular edge-gated strip. The dimensions of the rectangular strip were calculated through the original part's geometric mesh by using graph theory. Subsequently, a finite difference method was employed to simulate a non-isothermal and unidirectional flow in the strip. Numerical examples show that although FSA model is an approximation method, its results are approximately identical to that of detailed CAE software, while the running time of the proposed model is several magnitudes less than that of CAE software.

Publisher

Walter de Gruyter GmbH

Subject

Materials Chemistry,Industrial and Manufacturing Engineering,Polymers and Plastics,General Chemical Engineering

Link

https://www.degruyter.com/document/doi/10.3139/217.2343/pdf

Reference14 articles.

1. A Brief History of the Filling Simulation of Injection Moulding;Proc. Inst. Mech. Eng. C, J. Mech. Eng. Sci.,(2009)

2. A Neural Network-Based Approach for Dynamic Quality Prediction in a Plastic Injection Molding Process;Expert Syst. Appl.,(2008)

3. Application of Grey-fuzzy Logic on the Optimal Process Design of an Injection-molded Part with a Thin Shell Feature;Int. Commun. Heat Mass Transfer,(2006)

4. Injection Moulding Optimisation of Multi-class Design Variables Using a PSO Algorithm;Int. J. Adv. Manuf. Technol.,(2008)

5. Computer Simulation of Transport Processes during Injection Mold-Filling And Optimization of the Molding Conditions;J. Mater. Process. Technol.,(2002)

Cited by 4 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Residual wall thickness of water‐powered projectile‐assisted injection molding pipes;Polymer Engineering & Science;2018-10-30

2. Optimal design of heating system for electrical rapid heat cycle mold based on multi-objective optimization, multiple-attribute decision-making, and conformal design theory;Advances in Mechanical Engineering;2018-08

3. The CAE Technologies in the Field of Polymer Processing as Design Technique;Seikei-Kakou;2014-08-20

4. Numerical Implementation for the Filling and Packing Simulation;Computer Modeling for Injection Molding;2013-03-28