Affiliation:
1. Indian Institute of Technology, India
Abstract
Super alloys have been used widely in all sectors (e.g., automobile, aerospace, biomedical, etc.) for their properties like high hardness, high wear, and corrosion resistance. A central challenge is the significantly higher temperature and pressure on the cutting tool, hence rapid tool wear and bad surface finish. In the present study, a FEM analysis has been developed to calculate the effect of preheating temperature on the surface of the workpiece on tool wear on machining Inconel 718. Usui's tool wear model has been implemented in DEFORM software. In order to validate the results, an experimental investigation has been carried out with same cutting conditions. The evaluated results were also compared with the room temperature machining condition. It was observed that the heating temperature increased the tool life by reducing tool wear, tool temperature compared to room temperature machining condition. The predicted tool wear, tool temperature, and chip morphology have been compared with the experimental results and good correlation was found.