Distance Locator for an Underground Cable Fault-Reference-Cited by-同舟云学术

Distance Locator for an Underground Cable Fault

Published:2023-09-28 Issue: Volume: Page:314-318
ISSN:2581-9429
Container-title:International Journal of Advanced Research in Science, Communication and Technology
language:en
Short-container-title:IJARSCT

Author:

Rohit Khandu Jarande ¹,Juhi Liladhar Dawale ¹,Jatin Shailesh Chaudhari ¹,Sarthak Anna Shende ¹,Pooja Santosh Khandekar ¹,Keya Shailendra Gawai ¹

Affiliation:

1. Jawaharlal Darda Institute of Engineering and Technology Yavatmal, India

Abstract

In this paper, a way for sleuthing underground cable fault distance locator is done by using microcontroller. The target of this project is to work out the gap of underground cable fault through base station in kilometers. It uses the straight forward conception of ohm’s law, voltage drop can vary counting on the length of fault in cable, since the current varies. A group of resistors are used to represent the length of cable in kilometers and a dc voltage is fed at one end and the fault is detected the change in voltage using analog to voltage converter. The fault occurring at what distance is shown on LCD which is interfaced with the microcontroller that is used to make the necessary calculations.

Publisher

Naksh Solutions

Subject

General Medicine

Reference14 articles.

1. [1] B.Clegg, “Underground Cable Fault Location. McGraw- Hill, 1993.

2. [2] DhivyaDharani.A, Sowmya.T, “Development of a prototype of Underground Cable Fault Detector”, IJEECS, Vol-2, 2014.

3. [3] Dhekale P.M., Prof. Suryawanshi R.R., “Underground Cable Fault Distance Locator”, IJIERT, vol-2, April2015.

4. [4] M.-S. Choi, D.-S. Lee, and X. Yang, “A line to ground fault location algorithm for underground cable system,” KIEE Trans. Power Eng., pp. 267–273, Jun. 2005.

5. [5] J. Densley, “Ageing mechanisms and diagnostics for power cables—an overview,” IEEE Electronic Insulation Mag., vol. 17, no. 1, pp. 14–22, Jan./Feb. 2001.