The regeneration of the tools to cellulose cutting using electric arc surfacing method-Reference-Cited by-同舟云学术

The regeneration of the tools to cellulose cutting using electric arc surfacing method

Published:2023-06-30 Issue: Volume:122 Page:63-72
ISSN:1898-5912
Container-title:Annals of WULS, Forestry and Wood Technology
language:
Short-container-title:Annals of WULS - SGGW. Forestry and Wood Technology

Author:

Romaniuk Svitlana¹^ORCID,Barlak Marek¹^ORCID,Wilkowski Jacek²^ORCID

Affiliation:

1. Plasma/Ion Beam Technology Division, Material Physics Department, National Centre for Nuclear Research Świerk, 7 Andrzeja Sołtana St., 05-400 Otwock, Poland

2. Department of Mechanical Processing of Wood, Institute of Wood Sciences and Furniture, Warsaw University of Life Sciences, 159 Nowoursynowska St., 02-776 Warsaw, Poland

Abstract

The regeneration of the tools to cellulose cutting using electric arc surfacing method. The paper presents the laboratory results of the regeneration of the tools to cellulose cutting, using electric arc surfacing method. Three types of regenerating material was used in the rod electrodes form. Additionally, each material was applied with additional non-magnetic powder in the coating. Finally, the layer with the highest microhardness was covered with a ZrN coating in the Arc PVD process. The relative wear coefficient, the friction moment, the friction coefficient, the width of friction track and the microhardness were measured. The SEM observations and EDS investigations were applied for the studies of the microstructure of investigated materials. The best results were obtained for the regeneration using regenerating material, marked as “T-590 + powder”, with ZrN coating.

Publisher

Index Copernicus

Subject

General Medicine

Link

https://wulsannals.com/gicid/pdf/01.3001.0053.8669

Reference12 articles.

1. CHOO S.H., KIM C.K., EUH K., LEE S., JUNG J.Y., AHN S., 2000: Correlation of microstructure with the wear resistance and fracture toughness of hardfacing alloys reinforced with complex carbides, Metallurgical and Materials Transactions A no 31; 3041-3052http://www.splav-kharkov.com/mat_start.php?name_id=264

2. LIU D., LIU R., WEI Y., MA Y., ZHU K., 2013: Microstructure and wear properties of Fe–15Cr–2.5Ti–2C–xB wt% hardfacing alloys, Applied Surface Science no 271; 253-259

3. PRADEEP G.R.C., RAMESH A., DURGA PRASAD B., 2010: A review paper on hardfacing processes and materials, International Journal of Engineering, Science and Technology no 2; 6507-6510

4. ROMANIUK S., 2019: Development of technological process for restoring the surface of toоls made of high-carbon alloy steel, Bulletin of the National Technical University “KhPI”, Series: Innovative technologies and equipment handling materials in mechanical engineering and metallurgy no 26; 47-51

5. RYBALKO I., MARKOV O., 2022: Modification of the restored layer of wear parts during surfacing, Proceedings of the International scientific and technical conference "Strength and durability of modern materials and constructions; 166-167, in Ukrainian