Abstract
Abstract
Aiming at the shortcomings of the crank-connecting rod mechanism engine, such as low transmission efficiency and high side pressure between the piston and the cylinder, the paper proposes a kind of dual-rotor engine driving by the elliptic gear. The left and right rotors are driven by the gas pressure in the cylinder, and then the elliptic gears on the output shaft are driven by the circular gears and the elliptic gears on the intermediate shaft. When the gears rotate, the output shaft connected outputs power again and again. The rotor rotates one circle, the four “cylinders” separated by the rotor work one time respectively, and the output shaft rotates two circles. The results of the calculation and the simulation test show that the serialization design can be carried out by setting different parameters of the long half-axis and the eccentricity. When the value of the long half-axis (100mm in this design) is fixed and the eccentricity is 0.4, 0.6 or 0.8, the rotation angle and the speed of the left and right rotors change obviously. The greater the eccentricity, the greater the difference of the rotation angle and the speed of the left and right rotors. The higher the compression ratio of engine, the higher the transmission efficiency.