Influence of the Stand-off Distance and of the Layers Thickness on the Adhesion and Porosity of the 97MXC Deposits Obtained by Arc Spraying Process

Abstract

Abstract In this paper, the surfaces of some weakly alloyed steel specimens were covered, by arc spraying process, with a layer of high alloyed steel: 97MXC, using core wires. The technological parameters, used to spray the high alloy steel, were kept constant except for the spray stand-off distance (SOD) which varied on three levels. The research was performed on deposits with a thickness between 0.2-2.4 mm. The microstructure of the deposits, the chemical composition, the physical properties of the layers were investigated by SEM analyzes, X-ray diffraction, microhardness tests and adhesion tests. The porosity of the deposits was determined by optical microscopy. The adhesion of the layer to the substrate was researched by the tensile test. Studies have shown the fact that SOD significantly influences the adhesion and porosity of the deposits. Thus, the increase of SOD determines the decrease of the adhesion of the layer to the substrate by approximately 21.4%, the increase of the porosity of the deposits by approximately 14.2% and variations up to 5% of the microhardness.