Investigation of Technological Parameters for Machining Toroidal Section of Solid Ceramic End Mills

Abstract

Abstract Solid ceramic mills are a promising technological solution for cutting heat-resistant materials. Although nanostructured cutting ceramics has a number of valuable physical and mechanical properties providing high operational performance of mills, it has low strength. The design of a solid ceramic mills is formed by smooth surfaces without stress concentrators to ensure operability and to reduce the probability of failure. The most important structural element of solid ceramic end mill is a helical groove with a negative rake angle needed to increase surface strength. This groove can be machined with standard grinding wheels of type 1A1 or 1V1. However, the application of grinding wheels of a standard shape requires the use of reduced cutting parameters to prevent chipping on the forming sections of the cutter. Chipping can be caused by too short length of the contact line and the stress concentration at the end point of the profile of the grinding wheel, which is typically fully responsible for shaping the front surface and its transition to the tooth back. In this paper, in order to increase the contact line, we develop a new approach to designing grinding wheels for machining helical grooves of solid mills and determining rational technological and operational parameters for there use. A new approach is developed based on the fundamental principles of analytical geometry and linear algebra, numerical methods and basic axioms of the shaping theory. In this study, we have identified the key relationships between parameters determining the position of the grinding wheel relative to the workpiece and the geometrical parameters of a solid ceramic mills. The developed approach allowing to determine the specific design of the grinding wheel, depending on the initial parameters of the mill and the trajectory of the axis of the wheel relative to the mill, was implemented in the MathCAD environment.