Author:
Liu J,Guo Z P,Yuan Q,He X X,Miao S j
Abstract
Abstract
Based on the general machining center, a high-efficiency, mass-produced micro-turbine processing technology and a process scheme for improving metal removal rate are proposed to improve and optimize the metal removal rate of micro-machining. Taking the two-stage axial micro turbine air motor as the research object, the machining route of clamping the nozzle rotor is developed, and the metal removal rates of the turbine with the expandable surface when using the rounded end mill and the ball end mill are compared by the single factor analysis method. In the three processes of rough milling blade passage, finish milling blade and finish milling wheel hub, the metal removal rate of the rounded end mill is 2.96 times, 10 times and 2 times higher than the ball end mill, respectively. The Swarf finishing strategy of Powermill software is used to processing the side and bottom of the blade both roughly and accurately, and the suitable cutting parameters and side edge machining parameters are obtained. The surface roughness Ra of the side and bottom surfaces of the blade is tested to be 0.4-0.8μm using a surface roughness measuring instrument SJ-410. With the trigger type probe of the model Omp60, the dimensional tolerance of the blade is within 0.015 mm, and the coaxiality is from 0.002 to 0.003mm. The two-stage axial-type micro turbine air motor is assembled by the hot-packing method, and the torque and rotor speed are tested by a special platform. The results show that when the compressed air inlet pressure is 300KPa, the designed maximum speed of 100000rpm is satisfied, which meets the design requirement of the turbine motor and verifies that the numerical control machining process plan is feasible. Besides, the side edge machining of the blade using the cylindrical milling cutter is efficient to improve the metal removal rate. It also lays a foundation for the mass production of the two-stage axial-type micro turbine air motor.