Detection of cracks in green products of powder metallurgy by means of laser vibrometry

Abstract

Abstract Cracking of green parts in powder metallurgy (PM) is a big concern in PM industry. Detection of cracks in green parts before sintering can prevent recycling of already sintered parts or production of defective ones. As opposed to sintered parts, where the presence of cracks is well revealed by impact spectroscopy, it is challenging for green parts. The reason is an extremely low mechanical quality factor of these parts composed of compacted but non-sintered metal powder particles. Low mechanical integrity of particles causes the absence of pronounced resonances of the parts. The aim of the study was to test a possibility to discerning healthy and cracked green parts using spectral characteristics of signals obtained by laser vibromery. Four similar green PM gear wheels made of steel powder were obtained from a PM manufacturing company, two of them were healthy and two with simulated cracks that appeared in the area of stress concentration between the hub and the disc. The experimental setup included a Polytec PSV-500 scanning laser vibrometer and a Bruel&Kjer vibration stand type 4824. Integrated spectrograms in the frequency range 50 – 3500 Hz were recorded upon a 95-point network on the gear surface at different vibration intensities proportionally graded in the range from 1 to 5. Comparison of the 3D (frequency-intensity-amplitude) vibration spectrograms showed that the defected specimens with cracks differed from the healthy ones in the following features: resonance frequency shift and/or splitting of resonances when the load changes. The study confirmed the principal possibility of cracks detection in green PM parts using laser vibrometry regardless the crack location in the part. The aim of further studies is to determine the sensitivity limit in terms of crack size.