Investigation on Drill Wear and Micro Hole Quality in High Speed Drilling of High Frequency Printed Circuit Board

Abstract

Abstract Due to the severe wear of micro drill and the difficulty in controlling of hole quality, high speed drilling process of high frequency printed circuit board (PCB) was attracted comprehensive attention. In this investigation, the wear width of drills’ primary face was measured, and the wear morphologies of micro drills were studied at once. Furthermore, regularity of micro hole quality concerning drilling burr and nail heading while drilling with different types of drills were analyzed. The research results indicated that the wear width of diamond coating drill reduced slightly. Abrasive wear and adhesive wear were mainly occurred on uncoated drill and diamond like carbon coating drill, but some micro breaches and pits appeared on uncoated drill. Meanwhile, drilling with diamond like carbon coating drill could obtain better hole quality than drilling with uncoated ones. However, diamond coating drill performed well in terms of ability of wear resistance, as well as micro hole quality.