Numerical study of the equivalent roughness effect on the low-flow centrifugal compressor impeller characteristics

Abstract

Abstract The article presents the results of a numerical study of the effect of equivalent sandgrain roughness on the characteristics of a low-flow centrifugal compressor stage. Low-flow stages are widely used in high-pressure compressors as the last stages. These compressors are used for natural gas booster compressor stations, as well as in technological processes for the production of methanol, ammonia, high - pressure polyethylene, etc. The efficiency of the low-flow stages is lower than that of medium-and high-flow centrifugal compressors stages. Stages operate at high pressure and have low gas volume flow rates. For this reason they have narrow channels of the flow part, significant friction and leakage losses. The study was conducted in the Ansys CFX 19.2 software package. In the first part of the study, the low-flow stage numerical model is validated with the test results. Full-scale tests of the stage were carried out at the LPI-SPbPU earlie. In the second part of the study, impeller equivalent sand-grain roughness numerical study carried out. As a result, the characteristics of the stage were obtained at four different values of equivalent sand-grain roughness ks. The impeller losses were estimated. It is established that when the ks values increase, the polytropic head and efficiency values do not decrease equally over the entire characteristic. Characteristics are significantly reduced in areas of high expenditure and change slightly with minimal expenditure. The internal head coefficient varies slightly depending on ks.