Direction of chip flow for milling of shaped surfaces by ball end mill-Reference-Cited by-同舟云学术

Direction of chip flow for milling of shaped surfaces by ball end mill

Published:2018-09-01 Issue:1 Volume:412 Page:012060
ISSN:1757-8981
Container-title:IOP Conference Series: Materials Science and Engineering
language:
Short-container-title:IOP Conf. Ser.: Mater. Sci. Eng.

Author:

Ryabov E A,Khisamutdinov R M,Yu Yurasov S

Abstract

Abstract There investigated the direction of chip flow on the front surface by machining with non-cylindrical original instrumental surface end mills.

Publisher

IOP Publishing

Subject

General Medicine

Link

http://stacks.iop.org/1757-899X/412/i=1/a=012060/pdf

Reference7 articles.

1. Vliyanie ugla naklona vintovyh zub’ev frez na stojkost’;Golubev;[The influence of the angle of inclination of the screw teeth of cutters on the resistance] Stankii instrument,1959

2. Stand for monitoring the operational parameters of conjugations “ball support - Body of the tie-rod end” of automotive components;Safarov;IOP Conference Series: Materials Science and Engineering,2018

3. Creating a rigid model of solid end radius cutter in NX;Ryabov;IOP Conference Series: Materials Science and Engineering,2016

4. Study of deformations field in the working zone of vertical milling machine;Khusainov;Procedia Engineering,2017

Cited by 3 articles. 订阅此论文施引文献订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献

1. Behavior of the Abrasive Medium in a Single-Axis Vibration System;IOP Conference Series: Materials Science and Engineering;2021-03-01

2. Fitting Parameters in the Cylindrical Section of Ball-End Mills for Five-Coordinate Machine Tools;Russian Engineering Research;2020-01

3. Selection of thetoothdepthof the ball end mill based on the analysis of the working conditions of the tool;IOP Conference Series: Materials Science and Engineering;2019-07-01