Embrittlement of WCLL blanket and its fracture mechanical assessment

Abstract

Abstract In the European fusion programme, the Water Cooled Lithium Lead breeding blanket (WCLL BB) uses EUROFER as a structural material cooled with water at temperatures between 295 °C–328 °C and a pressure of 155 bar. The WCLL BB will be significantly irradiated (>2 dpa), while some parts will not receive significant heat loads, e.g. the sidewalls or the back-supporting structures. The irradiation, together with the irradiation temperature of EUROFER below 350 °C, produces a shift of the ductile-to-brittle-transition temperature (DBTT) to levels above room temperature at neutron doses, causing material damage as low as 2–3 dpa. Even though the DBTT does not reach the operating temperature level, brittle/non-ductile fracture is a concern during in-vessel maintenance when the BB temperature is below the DBTT. Two loading scenarios were identified as severe in this respect: (i) re-pressurization of the WCLL BB cooling loop after in-vessel maintenance, and (ii) dead weight loads during lifting of the BB segment. The embrittlement of the WCLL BB was investigated by quantifying the local DBTT shift in its parts based on current knowledge of the embrittlement behaviour of EUROFER under neutron irradiation. Therefore, a suitable, not overly conservative procedure was derived considering dpa damage and transmuted helium effects. The results demonstrate the ability to identify the 3D spread of the severely embrittled zones in the structure whose impact on the structural integrity was assessed considering the risk of brittle/non-ductile fracture. Thereby, the fracture mechanics approach established in nuclear codes was applied assuming its applicability to EUROFER. The embrittled zones in the first wall (FW) and its sidewalls pass the criteria when assessing the relatively low stresses resulting from the coolant pressure. The assessment was then continued considering stresses appearing in the FW during maintenance, in particular, when lifting the BB segment and transporting it out of the vacuum vessel. In this context, the maximum tolerable flaw sizes were determined in a parameter study considering designs of the FW with different cooling channel wall thicknesses.