Simulation of temperature field of A356 aluminum alloy in freeze casting

Abstract

Abstract In this paper, the temperature change curve of the casting and frozen sand mould during the solidification process of the A356 aluminum alloy in the frozen sand mould is tested. According to the actual temperature change curve of the casting surface and the sand mould surface, the interface heat transfer coefficient between the frozen sand mould and the A356 aluminum alloy could be reversed analysis. The results show that when the casting temperature is lower than 550 °C, the interface heat transfer coefficient remains about 750 W.(m2.K)-1; When the casting temperature is between 550 °C and 610 °C, the interface heat transfer coefficient increases significantly; when the casting temperature is higher than 610 °C, the interface heat transfer coefficient reaches the maximum value, which is about 2300W. (m2.K) -1. At this time, this study simulates the solidification temperature field of aluminum alloy hub parts in the frozen sand mould according to the interface heat transfer coefficient calculated by inverse analysis, and the temperature field of resin sand mould casting was used as for comparison. The results show that: under the same solidification time, the temperature field of A356 aluminum alloy hub parts in frozen sand mould is lower than that of resin sand casting, freezing casting can realize the high-speed solidification process of different parts of complex castings.