Author:
Rat C L,Ichim-Burlacu C I,Panoiu C
Abstract
Abstract
This paper is concerned with the modeling of the three-phase permanent magnet synchronous generator (PMSG) and its load in the dq0 reference system. The generator was considered to be directly connected to a balanced three-phase load. The loads under consideration were R and RLC type loads. The connection to the R load can be simulated using the standard PMSG dq model and Park transformations, but the connection to the RLC load requires the modeling of the system as a whole. LabVIEW simulations of these models were used in order to study the behavior of the PMSG under various load conditions (R, RL and RC). These models can be used to simulate the behavior of the PMSG in a conventional (natural gas, coal, etc.) or renewable (wind energy, hydropower, etc.) energy conversion system. They can also be used in designing the control of the energy conversion system (MPPT control, Droop control, etc.).
Subject
General Physics and Astronomy
Reference11 articles.
1. Control and Interface Design for Cost Reduction of a Low Power Grid- connected Wind-photovoltaic System;Musunuri,2011
2. Dual stator winding variable speed asynchronous generator: magnetic equivalent circuit with saturation, FEM analysis and experiments;Tutelea;IOP Conference Series: Materials Science and Engineering,2016
3. Permanent magnet generator design and control for large wind turbines;Xu,2012
4. Feasibility of a simple small wind turbine with variable-speed regulation made of commercial components;Cuesta;Energies,2013
5. Simulation of power control of a wind turbine permanent magnet synchronous generator system;Huang,2013