Comparative analysis of simulation options for the real geometry of the surfaces of gas turbine engine parts

Abstract

Abstract Geometric deviations of parts surfaces inevitably occur during parts manufacture. It is known that the accumulated defects of parts surfaces and assembly units impact their functional characteristics throughout the entire product life cycle. Often, assembly simulation and dimensional ties analysis of products are performed by using the nominal geometry of parts without taking into account geometric deviations of the shape and location of parts surfaces. The accuracy of dimensional analysis without taking into account geometric deviations of the shape and location of parts surfaces is not sufficient to solve technological problems in digital production. The purpose of this article is the study of the influence of methods and models for constructing the real geometry on the accuracy of its reproduction. The subject of the research is the assembly unit of the rotor of a low-pressure turbine of an aircraft engine. The article considers three methods for constructing the real geometry, which are used to realize assembly virtual simulation. Comparative results of assembly simulation with the use of considered methods of real geometry constructing are presented, as well as their influence on the controlled assembly parameters is estimated.