Mechanical Friction Simulation and Optimization Design of Floating Bearing of Mechanical Tricone Bit

Abstract

Abstract This paper aims to find out the most vulnerable position and the suitable clearance ratio of the floating sleeve between the inside and outside floating sleeve of the tricone bit. In this paper, the mechanical analysis model of the drill bit is established to get the simulated working condition of the tri-cone bit, and then the stress condition of the floating bearing is simulated. Finally, the multi-factor variable orthogonal test method is used to optimize the clearance ratio of the floating sleeve. The results show that the simulation results are consistent with the wear position of the floating sleeve: during the operation of the floating sleeve, the most vulnerable position is the edge position, the largest deformation is the opening position, the recommended internal clearance of the floating sleeve is 0.06–0.07 mm, the recommended external clearance is 0.02–0.04 mm, and the recommended internal clearance ratio is 2.0–2.4.