Research on Partial Discharge Characteristics of Suspension Defect in GIS under the Action of Voltage and Current

Abstract

Abstract Gas insulated switchgear (GIS) is a critical component in power system, and the insulation testing is crucial before putting it into operation. Despite passing AC withstand tests, some GIS equipment exhibit insulation faults during operation. Existing AC withstand tests fall short in detecting all insulation faults in GIS equipment. To address this issue, a proposal is made to conduct a comprehensive simulation of actual GIS equipment operating conditions through a combined voltage and current boost test, aiming to address the limitations of existing tests. This study, based on a 330kV GIS test platform, compares the partial discharge characteristics of suspension defects under traditional voltage-boosting mode and the combined voltage and current boost mode. The research investigates the influence of simultaneously applying voltage and current on discharge characteristics. It is observed that the voltage and current boost combined mode significantly increase the partial discharge inception voltage (PDIV) and the corresponding apparent discharge compared to other modes. The apparent discharge quantity after a certain period of current flow during the discharge development process is greater than that observed in other modes. The current notably enhances the ultrasonic amplitude of partial discharge. These findings establish an experimental foundation for conducting voltage and current combined boost tests in the field.