Author:
Maharaj S,Allegre O,Smith KL
Abstract
Abstract
Electrospray propulsion is a form of electrostatic propulsion that shows potential for use as a thruster on small satellites. Electrospray emitters traditionally use arrays of capillaries, however, this paper investigates the suitability of manufacturing an emitter by laser drilling holes in sheets of polytetrafluoroethylene (PTFE), also known as Teflon. This is done by examining factors such as the machining time, hole shape and degree of taper in holes drilled through different methods. Experimental work was done to determine the shape of holes drilled in a flat sheet, and a computational model was used to simulate the performance of these drilled holes. These results were used to judge if this would be a valid method to manufacture electrospray thrusters, and how these thrusters would compare to more traditional emitters. Based on these results, it was concluded that a PTFE sheet with a width of 0.81 mm would be sufficient to achieve electrospray at voltages lower than those needed for traditional emitters.
Subject
General Physics and Astronomy
Cited by
2 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献