Abstract
Abstract
The inlet rake is generally installed in aero-engine during rig and flight test for flow field pressure and temperature measuring. There are usually complex flow channels and pipelines inside the rake to extract air flow to the sensor. The laser powder bed fusion(L-PBF) technique was applied in rake fabrication recently due to its progressive layer stacking molding procedure. However, the difference of thermoforming method between L-PBF and the traditional casting process leads to the mechanical property disparities of the material. In this work, the determinants of random vibration response of the inlet rake manufactured by L-PBF with GH4169 powder were studied individually. The stiffness and yield property of the material were investigated by the specimen tensile test, which indicates higher elasticity modulus and yield stress comparing to the ones by castling or forging process. The damping ratio of the inlet rake was obtained through stress attenuation characteristics experiment and analysis under stepwise excitation. The stress distribution and resonance margin of the inlet rake under the aero-engine random vibration spectrum were simulated by finite element modal and random vibration analysis. The results showed that the damping ratio of the L-PBF inlet rake is much smaller than engineering recommendations, and the resonance margin is insufficient. Thus, the stress level of the inlet rake was very high, especially in the blade root section, quite close to the yield limit of the material. To solve this problem, the vibration suppression methods of the inlet rake were studied from the perspective of structural design optimization and damping ratio increasing. Through the rational design of the resonance margin and addition of vibration damping structure, the vibration stress of inlet rake was significantly suppressed. As the result, the rake was installed in the inlet during the aero-engine rig test for flow field pressure and temperature measurement successfully.