Author:
Xie Chunjie,Xiong Ziyu,Zhang Ailin,Zhou Zeran,Luo Qing
Abstract
Abstract
With the development of particle physics, higher
requirements are put forward for the brightness and energy of the
collider. A new collider — the Super Tau-Charm Facility (STCF) —
is under study in China. To meet the high acquirement of the quality
of the beam, a digital low-level RF (LLRF) system that achieves high
stability plays a critical role as a part of the microwave system of
Linacs. This paper introduces the design of a digital LLRF system
that works in the S-band (2856 MHz) as required by Linacs of the
STCF. The system architecture and hardware design as well as the
control algorithms and software design are discussed and tested. The
system includes a signal source, a frequency synthesis system and an
IF signal processor. The phase noise of the signal source is as low
as 20.3 fs, and the low-level IF signal processor adopts amplitude
and phase control by a PI-type controller. They jointly realize
ultra-low phase noise signal output. The table experiments show that
the short-term amplitude and phase stability of the system is better
than 0.01% and 0.01°, respectively. The beam experiments
show that the closed-loop phase stability in the cavity is about
0.1°. The results prove that the LLRF system meets the
requirement of the STCF.
Reference16 articles.
1. Preliminary Conceptual Study of Next Generation Tau-Charm Factory at China;Luo,2017
2. LCLS LLRF Upgrades to the SLAC Linac;Akre;Conf. Proc. C,2007
3. Digital I/Q demodulator;Ziomek;Conf. Proc. C,1996
4. A survey of CORDIC algorithms for FPGA based computers