Comparative research on the speed performance of Axial flux Permanent Magnet Generator (PMG)165 with manufacturing specification and experimental for implementation in the Low-Speed Wind Turbine System

Abstract

Abstract This paper is on working on energy assessment of generator’s voltage, current and power output based on the generator speed. Today, demand of power is increasing because of technology advancement and increasing electrical devices being manufactured and installed. For this reason, the generator applied in renewable energy is recommended. It must be improved because it is an important component inside the energy system in producing enough power. This research is used the DC Motor function as prime mover and direct shaft to the shaft connection of AFPM165. The parameters of the investigational research are generator speed (rpm), DC current value form generator output (Amp), and voltage value (V). The speed of DC Motor has been gradually increases, from 0 ∼ 300 rpm by adjusted speed adjustment knob. The series circuit 15-ohm resistor and 5 Watts lamp to make it total 19-ohm constant as a load. The result is presented that the more speed of generator, the more voltage, and current it can be inducted. The findings of the study are presented that there is a difference between the factory specification and the experiment where the experimental value is more than the factory specification value which is 11.43% variation.