SWE Modelling of Debris-flow body-sedimentation and Tail-flow Remobilization in a Check-dam Controlled Gully (Unzen Volcano, Japan) using UAV LiDAR, SfM-MVS

Abstract

Abstract On 13th August 2021 at Unzen Volcano (Japan), an 81 mm.hr-1 peak-rainfall (1486 mm in 2 weeks) triggered series of erosion and deposition features in the Tansandani and the Gokurakudani gullies, all adding up to 57,800 m3 of erosion and 39,600 m3 of deposition. Upstream of the Sabo dam located at the exit of the Tansandani Gully, a large deposit has been visually identified as a potential debris-flow front candidate. However, the absence of direct observation leaves some uncertainty on the process that deposited the material and the magnitude of the flow. In the present contribution, the authors are investigating (1) the role of the debris-flow body in constructing the deposit and (2) the role of the tail of the debris-flow in eroding the fresh deposit. To reach this objective, the authors have combined a field investigation with direct observation, UAV (Unmanned Aerial Vehicle) LiDAR (Light Detection And Ranging) and Photogrammetry, and GIS (Geographic Information System) analysis of the field data. From this data, a 2D hydrodynamic simulation and sediment transport models were applied. The results show that the debris-flow ran beyond the first Sabo dam, with part of the material trapped on both sides of the gully. Afterwards, a central channel connected to sub-channels conveyed the diluted flow, most probably < 25 cm with maximum velocities between 4 to 5 m.s-1 at peak flow. Only the debris-flow phase went over the internal shoulders of the Sabo dam. A lobe occupies the top half of the study area and its deposition has been discussed to be related to the sudden widening of the gully, while the lower half is connected to the base-level created by the check dam.