Abstract
Abstract
In order to investigate the effect of Ti element content on the microstructure and wear resistance of AlCrCuFeNiTix (x = 0, 0.3, 0.6, 0.9) high entropy surfacing alloy, a melting electrode gas shielded welding technology was used to prepare AlCrCuFeNiTix high entropy surfacing alloy on the surface of carbon steel plates. The microstructure, phase composition, and wear resistance of the alloy were analyzed. The results show that the phase composition of the surfacing alloy becomes a BCC+FCC solid solution phase, with a much higher content of BCC phase than FCC phase. The microstructure consists of disordered BCC phase rich in Fe and Cr, ordered BCC phase rich in Al and Ni, and FCC phase rich in Cu. The microstructure exhibits typical dendritic (DR) and interdendritic (ID) structures. With the increase of Ti element, hard Fe2Ti phase precipitates in the interdendritic zone, and the micro hardness of the alloy shows an increasing trend. The maximum hardness can reach 636 HV, which is 2.4 times that of the base material. With the increase of Ti element, the friction coefficient of the alloy shows a trend of first decreasing and then increasing, and the wear amount first decreases and then increases. When Ti is 0.6, the wear resistance of the high entropy surfacing alloy reaches its best.