Minimisation of pollution in the cotton fabric dyeing process with natural dyes by the selection of mordant type

Abstract

Purpose This paper aims to select a type of mordant from aluminium salts, namely, aluminium sulphate, aluminium nitrate and polyaluminium chloride (PAC) with the lowest potential for contamination so that their use will minimise pollution from natural dye waste. It also aims to determine the pollution value of natural dye immersion waste from jackfruit wood extract, secang wood, mangsi fruit and several synthetic dyes, to identify potential environmental pollution. Design/methodology/approach Dyeing with natural dyes was performed by exhaust at room temperature by the pre-mordant method, while with synthetic dyes it was performed by exhaust according to the dyeing procedure (reactive, vat and naphthol). The groundwater, mordant solutions, natural dye extract and the waste-water from the natural and synthetic dyes were then tested to determine their biological oxygen demand (BOD5), chemical oxygen demand (COD), total suspended solids (TSS), pH, Al and heavy metal contents such as chromium (Cr), copper (Cu), cadmium (Cd), nickel (Ni), cobalt (Co) and lead (Pb). Findings Aluminium sulphate had the lowest pollution load while PAC had the highest, as aluminium sulphate had a higher BOD5/COD ratio (0.62–0.67) than aluminium nitrate (0.56–0.64) or PAC (0.44–0.54). The dyeing waste from the three natural dyes contained an acidic pH of 3.5–4.2, Al of 75.280–621.34 mg/L, Cr of 0.154–0.215 mg/L and Cu of 0.035–0.072 mg/L. The values of TSS, COD and BOD5 are higher than the quality standards of the waste but are environmentally friendly because the ratio of the BOD5/COD values from the waste ranges from 0.44–0.67. Research limitations/implications The findings indicate that as a mordant, aluminium sulphate results in lower pollution loads than aluminium nitrate and PAC. However, all three mordants contain Cr and Cu, albeit in negligible concentrations. Therefore, it is recommended that future studies strive to identify a mordant that has lower pollution loads and does not contain metals but can increase dyeing results to satisfy consumer requirements. It is the hope that, with the discovery of a new mordant, natural dyes will be the solution for the heavy metal pollution caused by synthetic dyes. Practical implications The use of environmentally-friendly mordants and natural dyes in the Indonesian textile and batik industry will give rise to superior quality eco-textile and eco-batik products. Such environmentally-friendly and high-quality products will not only increase competition and consumer interest but increase product sales as well which will, in turn, increase incomes and the economy. Additionally, an increase in the use of natural dyes by the textile and batik industry will serve as additional income to the communities and farmers from which the raw materials for the natural dyes are sourced thereby creating jobs and increasing welfare. Social implications As environmentally-friendly mordants and natural dyes replace the hazardous and toxic materials currently used in the textile and batik industry, it guarantees the health and safety of its consumers and workers. Furthermore, as the waste-water produced is biodegradable, it reduces river and groundwater pollution. It is, therefore, expected that this information will not only lead to a shift in attitude within the textile and batik industries but the adoption of environmentally-friendly materials, for the sake of the environment, as well as the development of eco-textile and eco-batik products. Originality/value Aluminium sulphate is a mordant type of aluminium salt with a lower potential for contamination than aluminium nitrate and PAC. However, PAC has been discovered to be a mordant for natural dyes, as has the fruit of the mangsi shrub, which has recently been discovered as a naturally occurring blue dye.