Author:
V. Aleksandrov Alexander,V. Aleksandrov Valera
Abstract
Purpose
– The purpose of the study is to improve the quality of alumina-containing sinter produced in a rotary kiln. Simulating sintering furnace assessment of technical solutions aimed at creating optimal phase composition of clinker.
Design/methodology/approach
– The computer model of the sintering furnace is developed. Influence of characteristics of material streams on thermal processes in the furnace was considered. Balance of energy, including heat conductivity, convection and radiant heat exchange has been solved in a stable state. Between actual and calculated variables of work of the furnace, good correlation was observed.
Findings
– The evaluation of the effect of increasing primary air and fuel burner extension to changes in temperature of the material. The modeling found that the most effective solution to reduce the temperature of the sinter is lengthening fuel burner to 5 m.
Practical implications
– The model can be applied to analyze and optimize the alteration of temperatures of materials and gases in an industrial furnace under various conditions.
Originality/value
– The article provides new information for specialists in the production of alumina. For the first time shows the influence of cooling conditions on the alumina-containing sinter quality. According to the results of computer modeling, it has been established that for creating of optimal cooling conditions of the sinter in the furnace, the length of coal burner must be not less than 5 m.
Subject
Computational Theory and Mathematics,Computer Science Applications,General Engineering,Software
Reference12 articles.
1. Aleksandrov, A.V.
(2007), “Resonance character of polymorphic transformations for the phase transition α
L
→β-Ca2SiO4
”, Rus. J. of Non-Ferrous Metals, Vol. 48 No. 6, pp. 404-406.
2. Barr, P.V.
,
Brimacombe, J.K.
and
Watkinson, A.P.
(1989), “Heat-transfer model for the rotary kiln: part II – development of the cross-section model”, Met. Trans. B, Vol. 20B, pp. 403-419.
3. Gorog, J.P.
,
Brimacombe, J.K.
and
Adams, T.N.
(1981), “Heat transfer from flames in rotary kiln”, Met. Trans. B, Vol. 12B, pp. 55-70.
4. Khodorov, E.I.
and
Shmorgunenko, N.S.
(1978), Sintering Technician Charge of Alumina Industries, Metallurgy, Moscow.
5. Kramer, H.
and
Croockewit, P.
(1952), “The passage of granular solids through inclined rotary kilns”, Chem. Eng. Sci., Vol. 1, pp. 259-261.
Cited by
2 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献