Mechanical feasibility of ABS/HIPS-based multi-material structures primed by low-cost polymer printer

Abstract

Purpose The purpose of this paper is to fabricate acrylonitrile-butadiene-styrene (ABS)/high impact polystyrene (HIPS) based multi-material geometries using a low cost polymer printer. At the same time, efforts have been made to investigate the mechanical characteristics of the obtained prints and to perform the optimization using the Taguchi-Grey (TGRA) method. Design/methodology/approach Initially, the feedstock materials were in-house fabricated in the form of filament wires, workable with fused filament fabrication (FFF) technique, of 1.75 ± 0.1 mm diameter by using a single screw extruder. Multi-material structures were fabricated using variable parameters (such as: raster angles, layer height, fill density and solid layers) and the experimentation was conducted as per Taguchi L18 array. Mechanical responses obtained by performing tensile, impact and bending test were studied in response to input variables and ultimately optimized settings were obtained, for individual as well as multiple parameters). Scanning electron microscopy (SEM) analysis was performed to analyze the fractured surfaces. Findings The Signal/Noise (S/N) plots for the quality characteristics highlighted that selected input parameters significantly influenced the obtained values for tensile strength, impact strength and flexural strength. Micrographs of the fractured specimens showed the occurrence of brittle fracture with higher levels of perimeter, infill density and solid layers. The extent of delamination was also increased under the bending load and further increased by increasing solid layers. Practical implications The results of the study strongly advocated the utility of fabricated multi-materials structures in automotive, aerospace and other manufacturing industries. Originality/value This work represents the fabrication, testing and analysis of polymer-based multi-material structures for engineering applications.