Sintering and hot corrosion of yttria silicate tablets in molten salts prepared by spark plasma sintering

Abstract

Purpose This paper aims to study the microstructural hot corrosion behaviour of the sintered Y2SiO5 ceramic silicate under a Na2SO4 + V2O5 mixture at an engine representative temperature of 1150°C. Y2SiO5 is a promising candidate for thermal barrier coatings (TBC) due to its excellent chemical stability at high temperatures. As a continuous source of Y3+, it is expected that Y2SiO5 environmental barrier coating may prolong the lifetime of TBC systems by stopping the degradation caused by the loss of the Y2O3 stabilizer. Design/methodology/approach Two routes were chosen for the yttria silicate powder synthesis by sol-gel from TEOS and APTES precursors as the difference in Si source changed the ratio of Y2SiO5/Y2Si2O7 phases. Hot corrosion studies using Na2SO4 and V2O5 mixtures were conducted on both surfaces of APTES and TEOS tablets at 1150°C for 8 h in atmospheric air. The morphology and microstructure analyses of the silicate samples after hot corrosion tests were carried out using a SEM and X-ray diffraction analyse techniques. Findings Based on the degradation, the general status of the APTES tablet after hot corrosion presents a better hot corrosion resistance at a temperature of 1150°C than does that of the TEOS tablet. In the TEOS tablet, the crystal morphology of NaY9Si60O26 woodchip shapes with a size of 60 µm is developed on the surface for finally initiating some cracks. In the APTES case, the crystal morphology of rod-like shapes with a size of 100 µm is developed; hence, a dense thick layer predominately postpones the reaction of V2O5 and Na2SO4 with yttria silicate, and consequently, less damage is observed. Originality/value Coating yttria silicate preparation is very complicated; the problems of a high synthesis temperature, long production period and low yield still need to be solved. Under these perspectives, ceramics prepared via spark plasma sintering (SPS) can reach theoretical high densities and a fine grain size can be retained after the SPS process; hence, well resistance to the corrosion in molten salts is expected to obtain for the sintered yttria silicate tablets.