Investigation on the wall thickness variation of an eccentric tube in the rotary draw bending process

Abstract

PurposeWhen bending a large diameter thin-walled tube, the thickn ess of outer side wall will reduce greatly, which leads to a decrease of structural strength of the tube. To solve this problem, this paper investigated the deformation principles of an eccentric tube in the rotary draw bending process, trying to find a way to reduce the wall thickness difference between inner and outer diameters.Design/methodology/approachAn finite element model is established for analyzing the deformation of an eccentric tube in rotary draw bending process. The wall thickness distribution of the formed pipe was analyzed along the axis and diameter, respectively.FindingsIt is found that there exists an optimal eccentricity between the inner and outer circle center of the tube cross-section. If the eccentricity of the tube is chosen properly, it is possible to get a bent tube with equal thickness of inner and outer side walls. In addition, it is also found the optimal eccentricity on the cross-section can be influenced by bending radius, wall thickness, diameter and bending angle. The optimal eccentricity increases greatly with the decreasing of bending radius, the increase of outer diameter and the increase of wall thickness. The influence of bending angle on the optimal eccentricity can be divided into two situations. When the bending angle is small, the optimal eccentricity increases with the increase of bending angle. When the bending angle exceeds a certain value, the pipe enters a stable forming state. The optimal eccentricity of the stable forming region does not change with the bending angle.Originality/valueSuch a research is beneficial for reducing the thickness difference between inner and outer side walls in the rotary draw bending process.