Numerical investigations on delaminated Glare under uni-axial tension

Abstract

Purpose – Since failure of laminated composites by delaminations is common, the purpose of this paper is to present a numerical procedure to check the stability of delaminations in fiber metal laminate (Glare), with different possible damage configurations, under uni-axial tension. Deformation behavior of the laminate is also examined. Influence of the type and the extent of damage, represented by varying sizes and number of delaminations, on delamination driving force and laminate deformation is found. Design/methodology/approach – Delaminated Glare is modeled by finite element method. Interface cohesive elements are used to model the delaminations. Finite element results provide the deflection/deformation characteristics of the laminate. Driving forces of delaminations are estimated by J integrals that are numerically obtained over cyclic paths near delamination tips. Laminates with different types of delaminations are also fabricated and externally delaminated for measurement of their interlaminar fracture toughness. The delamination is considered to be stable if its driving force is less than corresponding interlaminar fracture toughness of the laminate. Findings – Delaminations are found to be stable in laminates with lower number of delaminations and unstable in laminates with higher number of delaminations. Increase in size of delaminations increases the deformations but reduces the delamination driving force whereas increase in number of delaminations increases both deformations and driving forces. The trends change in case of laminates with symmetrical damage. Shape of delamination is also found to influence the deformations and driving forces. The finite element model is validated. Research limitations/implications – There is scope for validating the numerical results reported in the paper by theoretical models. Practical implications – Checking the stability of delaminations and their effect on deformation behavior of the laminate helps is assessment of safety and remaining life of the laminate. If failure is predicted, preemptive action is taken by using repair patch ups at identified critical locations in order to avoid failures in service conditions. Originality/value – The paper offers the following benefits: use of cohesive zone method that is readily possible in finite element procedures and is relatively simple, fast and reasonably accurate is demonstrated; suitability of using J integrals over paths crossing non-homogeneous and property mismatched material layers is tested; and influence of the type and the extent of damage in the laminate on its deformation behavior and delamination driving forces is found. This type of work has not been reported so far.