Micromechanical response of SAC305 solder alloy under gamma radiation via nanoindentation approach

Abstract

Purpose This paper aims to investigate the effect of different doses of gamma radiation on the micromechanical response (hardness properties and creep behaviour) of 96.5Sn-3.0Ag-0.5Cu (SAC305) solder alloys. Design/methodology/approach SAC305 solder pastes deposited on printed circuit boards (PCBs) were subjected to a reflow soldering process to form soldered samples. The soldered samples were irradiated with a gamma source at different doses (5–50 Gy). Nanoindentation testing was used to determine the hardness properties and creep behaviour after gamma irradiation. Findings The results showed that the hardness of SAC305 solder alloys gradually increased up to 15 Gy and then gradually decreased to 50 Gy of gamma irradiation. The highest hardness value (0.37 GPa) was observed on SAC305 solder alloys exposed to 15 Gy irradiation. Hardening of SAC305 solder alloy was suggested to be due to the high defect density induced by the gamma irradiation. Meanwhile, exposure to 50 Gy irradiation resulted in the lowest hardness value, 0.13 GPa. The softening behaviour of SAC305 solder alloy was probably due to the evolution of defect size in the solder joint. In addition, the creep behaviour of the SAC305 solder alloys changed significantly with different gamma irradiation doses. The creep rates were higher at a dose of 10 Gy up to a dose of 50 Gy. Gamma irradiation caused the SAC305 solder alloy to become more ductile compared to the non-irradiated alloy. The stress exponent also showed different deformation mechanisms with varying gamma doses. Originality/value Research into the micromechanical properties of solder alloys subjected to gamma irradiation has rarely been reported, especially for Sn-Ag-Cu lead-free solder. Thus, this research provides a fundamental understanding of the micromechanical response (hardness and creep behaviour) of solder, especially lead-free solder alloy, to gamma irradiation.