Abstract
Purpose
– The purpose of this paper is to develop a methodology to reduce the field failures of splined shafts. The paper also demonstrates the application of Mahalanobis-Taguchi system (MTS) for identifying the optimum hardness profile to avoid failures.
Design/methodology/approach
– Through the usage profile analysis and comparison between the failed and good shafts, the major reason for shaft failure was identified as hardness variation. Then MTS approach was used to identify the optimum hardness profile for the shafts. An experiment was designed with power, feed and the gap between inductor and quench ring representing the heat transfer rate, heat removal rate and the time between heat transfer and removal of induction hardening process as factors. Based on experimental results, the optimum combination factors that would reduce the variation around the optimum hardness profile were identified.
Findings
– The study showed that the shaft failures can be reduced by optimizing the hardness profile of the shafts rather than warning customers on overloading, changing the raw material or investing on machining operation to achieve better shaft finish. The study suggested heat transfer rate, heat removal rate and the time between heat transfer and removal had significant impact on the shaft's hardness profile. The study resulted in reducing the field failures from 0.32 to 0.029 percent.
Practical implications
– This study provides valuable information on how to identify optimum hardness profile using MTS methodology to reduce shaft failures and how to minimize the variation around the optimum hardness profile using design of experiments.
Originality/value
– To the best of author's knowledge, no study has been conducted to identify optimum hardness profile using MTS methodology. The study also provides an approach to minimize the variation around a non-linear hardness profile using design of experiments.
Subject
Strategy and Management,General Business, Management and Accounting
Reference45 articles.
1. Akhyar, G.
,
Che Haron, C.H.
and
Ghani, J.A.
(2008), “Application of Taguchi method in the optimization of turning parameters for surface roughness”, International Journal of Science Engineering and Technology, Vol. 1 No. 3, pp 60-66.
2. Al-Darrab, I.A.
,
Khan, Z.A.
,
Zytoon, M.A.
and
Ishrat, S.I.
(2009), “Application of the Taguchi method for optimization of parameters to maximize text message entering performance of mobile phone users”, International Journal of Quality & Reliability Management, Vol. 2 No. 5, pp. 469-479.
3. Al-Refaie, A.
and
Li, M.
(2010), “Alpha error of Taguchi method with different OAs for NTB type QCH by simulation”, Quality Technology & Quantitative Management, Vol. 7 No. 4, pp. 337-351.
4. Asada, M.
(2001), “Wafer yield prediction by the Mahalanobis-Taguchi system”, IEEE International Workshop on Statistical Methodology, Vol. 6, pp. 25-28.
5. Barsoum, I.
and
Khan, F.
(2012), “Strength optimization of induction hardened splined shaft – material and geometric aspects”, International Journal of Mechanical and Aerospace Engineering, Vol. 6, pp. 377-380.
Cited by
9 articles.
订阅此论文施引文献
订阅此论文施引文献，注册后可以免费订阅5篇论文的施引文献，订阅后可以查看论文全部施引文献