Author:
Bharti Sarita,Selvaraj Senthilvelan
Abstract
Purpose
This paper aims to understand the effect of the manufacturing process on the frictional and wear performance of polyamide.
Design/methodology/approach
Pin specimens were manufactured through injection moulding (IM) and selective laser sintering (SLS) manufacturing processes. The friction and wear performance was evaluated using a pin-on-disc configuration under dry and oil-lubricated conditions. The friction coefficient, wear resistance and surface temperature of specimens were measured, and failure morphology analysis was carried out to understand the mechanism.
Findings
SLS material exhibited significantly less friction, wear and surface temperature than IM material under dry conditions. Reduced ductility due to the sintering contributes to reduced friction, wear and heat generation. Under the dry condition, IM material exhibited plastic flow and roll-shaped deformation, whereas SLS material exhibited only local degradation due to its lesser ductility. Lubrication reduced friction and temperature for both SLS and IM materials. The porous nature of the sintered surface absorbed the lubricant and released it while sliding, which is confirmed by the brown-coloured wear track.
Originality/value
The study provides valuable input to the designers on the sliding contact performance of commonly adopted two different manufacturing processes of polymers; IM and SLS manufacturing.
Subject
Surfaces, Coatings and Films,General Energy,Mechanical Engineering
Reference20 articles.
1. Mechanical and microstructural properties of nylon-12/carbon black composites: selective laser sintering versus melt compounding and injection molding;Composites Science and Technology,2011
2. Effect of surface orientation on the tribological properties of laser sintered polyamide 12;Polymer Testing,2015
3. Influence of surface characteristics on fatigue behaviour of laser sintered plastics;Rapid Prototyping Journal,2012
4. The effect of different metallic counterface materials and different surface treatments on the wear and friction of polyamide 66 and its composite in rolling–sliding contact;Wear,2003
5. Investigation of mechanical and physical properties of several industrial rubbers;Materials & Design,2004