Numerical simulation of shear-induced instabilities in internal solitary waves

Abstract

AbstractA numerical method that employs a combination of contour advection and pseudo-spectral techniques is used to simulate shear-induced instabilities in an internal solitary wave (ISW). A three-layer configuration for the background stratification, in which a linearly stratified intermediate layer is sandwiched between two homogeneous ones, is considered throughout. The flow is assumed to satisfy the inviscid, incompressible, Oberbeck–Boussinesq equations in two dimensions. Simulations are initialized by fully nonlinear, steady-state, ISWs. The results of the simulations show that the instability takes place in the pycnocline and manifests itself as Kelvin–Helmholtz billows. The billows form near the trough of the wave, subsequently grow and disturb the tail. Both the critical Richardson number (${\mathit{Ri}}_{c} $) and the critical amplitude required for instability are found to be functions of the ratio of the undisturbed layer thicknesses. It is shown, therefore, that the constant, critical bound for instability in ISWs given in Barad & Fringer (J. Fluid Mech., vol. 644, 2010, pp. 61–95), namely${\mathit{Ri}}_{c} = 0. 1\pm 0. 01$, is not a sufficient condition for instability. It is also shown that the critical value of${L}_{x} / \lambda $required for instability, where${L}_{x} $is the length of the region in a wave in which$\mathit{Ri}\lt 1/ 4$and$\lambda $is the half-width of the wave, is sensitive to the ratio of the layer thicknesses. Similarly, a linear stability analysis reveals that${\bar {\sigma } }_{i} {T}_{w} $(where${\bar {\sigma } }_{i} $is the growth rate of the instability averaged over${T}_{w} $, the period in which parcels of fluid are subjected to$\mathit{Ri}\lt 1/ 4$) is very sensitive to the transition between the undisturbed pycnocline and the homogeneous layers, and the amplitude of the wave. Therefore, the alternative tests for instability presented in Fructuset al. (J. Fluid Mech., vol. 620, 2009, pp. 1–29) and Barad & Fringer (J. Fluid Mech., vol. 644, 2010, pp. 61–95), respectively, namely${L}_{x} / \lambda \geq 0. 86$and${\bar {\sigma } }_{i} {T}_{w} \gt 5$, are shown to be valid only for a limited parameter range.