Abstract
AbstractMetamaterial lenses are appealing thin alternatives to conventional dielectric lenses. In this contribution we describe their design and application in two exemplary 77 GHz automotive radar sensors operating in monostatic and bistatic modes. The frontends are built around commercially available MMICs and small feed antennas are used in coordination with the six-layer printed circuit board-based realizations of metamaterial lenses. The design follows the principles of dielectric lenses, while the required local phase shift is obtained from a set of metasurface bandpasses. Their design uses a novel interpolation procedure to extract layout parameters for a given phase shift. Despite the small structural sizes due to the high frequency, the fabricated frequency-selective surfaces show very good performance in the required frequency range. Verification measurements were conducted on single bandpasses as well as on metamaterial lenses mounted on the radar frontend. The results agree very well with the simulation and confirm the applicability of thin lenses operating at mm-wave frequencies for automotive radar applications.
Publisher
Cambridge University Press (CUP)
Subject
Electrical and Electronic Engineering
Cited by
2 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献