Evaluation of exotic soybean accessions and their use in developing improved soybean lines with resistance to Phomopsis seed decay

Abstract

Poor seed quality of soybean is often associated with Phomopsis seed decay (PSD), which is one of the most economically important seed diseases. Diaporthe longicolla (syn. Phomopsis longicolla) is the primary cause of PSD. Control of PSD is best accomplished by planting PSD-resistant cultivars. Sixteen exotic soybean accessions from the USDA soybean germplasm collection were screened for reaction to PSD at Stoneville, Mississippi. They consisted of maturity groups (MG) II, III and IV. Seeds from inoculated and non-inoculated plots harvested either promptly at maturity, or after a two-week delay in harvest, were assessed for infection by D. longicolla. Seed infection ranged from 0 to 36.7%. Overall, PI 417050 (MG II), PI 417017 (MG III), and PI 594692 (MG IV) had significantly (P ≤ 0.05) lower percentages of seed infected by D. longicolla and higher seed germinations than other genotypes in the same maturity groups. PI 587982A also performed well. As a result of these findings, these resistant accessions were used over multiple cycles of breeding to develop improved breeding lines with resistance to PSD and low seed damage. Breeding line 11043-225-72, with combined resistance from both PIs 417050 and 587982A, had low scores for PSD (6.7%) and seed damage (3.4%), while DS65-1, deriving resistance from PI 587982A, had the lowest seed damage score (1.1%) and the highest seed germination (85.6%) among all lines tested in 2017. DS65-1 and 11043-225-72, along with five other improved breeding lines, were provided to public soybean breeders for developing improved cultivars and germplasm lines. DS31-243 (PI 700941), derived from PI 587982A, was publicly released by the USDA in 2022. This research will lead to future releases of improved germplasm lines and cultivars with PSD resistance and high seed quality. It will also aid in disease management and be a benefit to soybean producers and the industry at large.