Study on treatment of wastewater with low concentration of ammonia-nitrogen by vacuum plate membrane distillation technology

Abstract

Abstract The removal of low concentration ammonia-nitrogen in industrial wastewater is necessary before discharged into the environment. In this study, vacuum plate membrane distillation (VPMD) technology was utilized and operating parameters such as pH, feed temperature, vacuum degree, feed flow and time were investigated. Based on the experimental data, the heat and mass transfer mechanism and mathematic model were studied. The experimental results show that low solution pH was significantly beneficial to ammonia-nitrogen removal but permeate flux was nearly changeless. At pH = 4, a removal rate up to 93.33% was achieved. Ammonia-nitrogen mainly exists with NH4+ ions in acidic solution, so only water molecules pass through the membrane to acquire the water product in the permeate side. Increasing the temperature of the solution was disadvantageous to the ammonia-nitrogen removal due to membrane pores expanding and the mass transfer coefficient of NH3 molecules increasing; therefore a low temperature was chosen if possible. Because vapor pressure of the feed solution increases exponentially with temperature and results in membrane surface pressure difference increases, therefore increasing the temperature enhances the permeate flux. Raising the vacuum degree enhanced ammonia removal rate and permeate flux obviously, a vacuum degree of 0.09 MPa was chosen for the experiment. The effect of feed flow rate on ammonia-nitrogen removal instead of permeate flux is weak, the reason is that the boundary layer wears thin when the feed flow rate is increased, which is conducive to permeate flux increasing. In a two-parameter model of Knudsen diffusion, Poiseuille flow was chosen to demonstrate the heat and mass transfers in the process of VPMD in the study. Based on the experimental values of permeate flux, two parameters CK and CP in the model were calculated using a nonlinear fitting method software, which indicated that the Knudsen diffusion model more than the Poiseuille flow model was suitable. The maximum values of the relative average deviation (RAD) and root mean square difference (RMSD) of experimental and calculated values with model equations of the permeate flux at the different temperature, vacuum degree and feed flow rate were no more than 8.7% and 3.20 kg · (m2 · h)−1, respectively.