1. Campatelli, G., Montevecchi, F., Venturini, G., et al., Integrated WAAM-subtractive versus pure subtractive manufacturing approaches: an energy efficiency comparison, Int. J. Precis. Eng. Manuf., 2020, vol. 7, no. 1, pp. 1–11.
2. Filomeno, M., Investigation of methods to manipulate geometry, microstructure and mechanical properties in titanium large scale Wire+Arc Additive Manufacturing, PhD Thesis, Bedford, MK: Cranfield Univ., 2014.
3. Kirichek, A.V., Solov’ev, D.L., and Silant’ev, S.A., Influence of the modes of static-pulse processing on the uniformity of hardening of the surface layer, Kuznechno-Shtampovochnoe Proizvod.–Obrab. Mater. Davleniem, 2004, no. 2, pp. 13–17.
4. Hönnige, J.R., Davis, A.E., Ho, A., et al., The effectiveness of grain refinement by machine hammer peening in high deposition rate wire-arc AM Ti–6Al–4V, Metall. Mater. Trans. A, 2020, vol. 51, no. 7, pp. 3692–3703.
5. Vázquez, L., Rodríguez, N., Rodríguez, I., et al., Influence of interpass cooling conditions on microstructure and tensile properties of Ti–6Al–4V parts manufactured by WAAM, Weld. World, 2020, vol. 64, no. 8, pp. 1377–1388.