Meyve Kabuğu tozları Takviyeli Ahşap Plastik Kompozit (APK) Malzemelerin Mekanik Özelliklerinin Belirlenmesi ve I-Tipi Snap-Fit Modeli için Örnek Çalışma
Author:
ERDEMİR Fulya1ORCID, ÖZKAN Murat Tolga2ORCID
Affiliation:
1. Gazi University, Turkey 2. GAZİ ÜNİVERSİTESİ
Abstract
High quality material production has been among the work of many researchers in recent years. These materials, which are obtained mostly by the production of composite materials, enable the production of lighter, more durable and less costly products. Increasing environmental pollution in recent years, protection of natural resources and ensuring recycling have increased the importance of wood plastic composite material production. In this study, wood plastic composite material was obtained by using ABS (Acrylonitrile butadiene styrene) plastic material and six different fruit shell powders (walnut, pistachio, peanut, almond, hazelnut and apricot shell). The mechanical properties of the obtained composite material were determined and its effect on the I type snap-fits was analyzed in ANSYS software. When the resulting composite material's mechanical properties were tested, it was found that the density and tensile strength decreased while the Vicat softening point value and melt flow rate increased. In the analysis performed using the ANSYS software, it was found that the composite I type snap-fit design of the same size can resist 12.6% N less force when the material is subjected to its maximum values when it achieves the elongation at break value.
Funder
GAZİ ÜNİVERSİTESİ BAP BİRİMİ
Publisher
Politeknik Dergisi
Reference41 articles.
1. [1] Wang, C., Mei, J., Zhang, L., “High-added-value biomass-derived composites by chemically coupling post-consumer plastics with agricultural and forestry wastes”, Journal of Cleaner Production, 284: 124768, (2021). 2. [2] Väisänen, T., Haapala, A., Lappalainen, R., Tomppo, L., “Utilization of agricultural and forest industry waste and residues in natural fiber-polymer composites: A review”, Waste Management, 54:62-73, (2016). 3. [3] Pratheep, V., G., Priyanka, E.,B., Thangavel, S., Gousanal, J., J., Bijoy Antony, P.,T., Kavin, E.,D., “Investigation and analysis of corn cob, coir pith with wood plastic composites”, Materials Today: Proceedings, 44(1): 549-555, (2021). 4. [4] Abhiram, Y., Das, A., Kumar Sharma, K., “Green composites for structural and non-structural applications: A review”, Materials Today: Proceedings, 44(1): 2658-2664, (2021). 5. [5] Gardner, D.J., Han, Y. & Wang, L, “Wood–Plastic Composite Technology”, Curr Forestry Rep, 1:139–150, (2015).
|
|