On the question of hardening of a slug poured along the wall of a rotating mold-Reference-Cited by-同舟云学术

On the question of hardening of a slug poured along the wall of a rotating mold

Published:2024-06-20 Issue:5 Volume:80 Page:31-36
ISSN:2619-0753
Container-title:Ferrous Metallurgy. Bulletin of Scientific , Technical and Economic Information
language:
Short-container-title:Černaâ metallurgiâ. Bûlletenʹ naučno-tehničeskoj informacii

Author:

Chumanov I. V.¹,Sergeev D. V.¹,Vyatkin G. P.²,Fedorov A. A.¹

Affiliation:

1. Zlatoust branch of South Ural State University (National Research University)

2. South Ural State University (National Research University)

Abstract

A comparative analysis of metal pouring into rotating molds using the siphon method and top pouring was performed. A new top pouring method is proposed to reduce defects of shrinkage origin: looseness, central porosity, liquation, etc. The method is based on rotating the mold during pouring around its axis or moving a metal melt stream relatively to the rotating mold. The peculiarity of the process is that steel pouring is carried out along the inner wall of the mold. The results of experimental cold physical modeling are presented. A glycerol solution was used as a model liquid. The results of cold modeling showed that implementing the proposed pouring method results in temperature losses averaging up to 5%. Taking into account the scale factor, higher values can be expected in a real process.

Publisher

South Ural State University

Reference14 articles.

1. Kuz'mina D. V., Stolyarov A. M. Temperature mode of casting steel of different grades on a longitudinal CCM. Tekhnologii metallurgii, mashinostroeniya i materialoobrabotki, 2020, no. 19, pp. 20–27. (In Russ.).

2. Gamanyuk S. B., Rutskii D. V., Zyuban N. A. etc. Application of physical simulation to evaluate the impact of teeming method and rate on axial zone formation of large ingots. Izvestiya vuzov. Chernaya metallurgiya, 2022, vol. 65, no. 11, pp. 814–823. (In Russ.).

3. Anikeev V. V. Issledovanie kachestva slitkov iz legirovannykh stalei pri sifonnoi razlivke v izlozhnitsy pod teploizoliruyushchei smes'yu [Investigation of ingot quality from alloyed steels at siphon casting into liners under the heat-insulating mixture]. Vysokie tekhnologii v mashinostroenii: materialy XIX Vserossiiskoi nauchno-tekhnicheskoi konferentsii s mezhdunarodnym uchastiem, 2022, pp. 128–130. (In Russ.).

4. Zavalishina A. N., Stolyarov A. M., Potapov I. M. etc. About the yield of the finished metal at the converter steel production. Teoriya i tekhnologiya metallurgicheskogo proizvodstva, 2022, vol. 43, no. 4, pp. 23–26. (In Russ.).

5. Esmakova A. S. Issledovaniya fizicheskoi i khimicheskoi neodnorodnosti slitkov konverternoi stali [Studies of physical and chemical heterogeneity of converter steel ingots]. Nauka i molodezh': problemy, poiski, resheniya: trudy Vserossiiskoi nauchnoi konferentsii studentov, aspirantov i molodykh uchenykh, 2022, pp. 415–419. (In Russ.).