Abstract
There are innumerable events related to heat transfer that we experience or see in our daily lives. In this study, research and experimental calculations were made about multilayer plane walls, which are often made of different materials. There are so much application areas on heat transfer. In order to better understand heat conduction, we need to make an explanation of the thermal properties and heat transfer type of the materials used in the experiment. It is known that heat transfer occurs in three different ways (conduction, convection, radiation). In this study, a layered wall heat conduction mechanism was established by combining 6 different materials (Copper, St37 Steel, AISI 1050 Aluminum, Wood, Rock wool, Glass wool) with different pediments of 30*30 cm. Heat is produced by gradually applying voltage from the copper plate and the temperature between each plate is measured by temperature sensors with Arduino programming. In the Arduino assembly, one Arduino Unocard, 5 lm35 temperature sensors and 1 20*4 I2C LCD screen are used to take the measurement outputs. The LM35 temperature sensor produces a voltage between zero and 5 V from the analog output, and the temperature measurement is made by producing a value of 10mV for each degree Celsius. The right leg of lm35s with three legs is connected to GND on the breadboard for grounding, the middle leg is connected to the analog output on the uno board, the left leg is connected to the 5V input on the breadboard and 5 lm35s are connected in parallel on the breadboard. The sensors were placed in the middle of the plates and the measurements were printed and recorded on the LCD screen. The measurements in the experimental setup were analyzed by applying a stepped voltage of the same value to the layered wall designed from the same materials in the SolidWorks thermal program, the data were collected and compared with the theoretical calculations of heat transfer.
Publisher
Orclever Science and Research Group
Reference11 articles.
1. Tsilingiris, P.T. (2002). On the Transient Thermal Behaviour of Structural Walls-the Combined Effect of Time Varying Solar Radiation and Ambient Temperature. Renewable Energy, 27, 319-336.
2. Asan, H. ve Sancaktar, Y.S. (1998). Sanki Sürekli Periyodik Durum İçin Duvarların Isıl Performansını Hesaplayan Bir Bilgisayar Programının Geliştirilmesi. 5.Ulusal Soğutma ve İklimlendirme Tekniği Kongresi, Çukurova Üniversitesi, Adana, 422-431.
3. Durgun, İ. ve Derbentli, T. (1993). Duvarlarda Geçici Rejimde Isı Transferi. Isı Bilimi ve Tekniği 9. Ulusal Kongresi, Fırat üniversitesi, Elazığ, TIBTD Yayın No. 21, 34-43.
4. Al-Regib, E. ve Zubair, S.M., “Transient Through Insulated Walls”, Energy, Cilt 20, No7, 687-694, 1995.
5. ÇAĞATAY, H. (1997). Isı iletkenliği düşük malzemelerde, ısı iletim katsayısının deneysel olarak incelenmesi. Niğde: Niğde Üniversitesi Fen Bilimleri Enstitüsü Makina Mühendisliği.