Comparative Evaluation of the Damping Capacity of As-cast and t6 Temper a 356-sic AMMCS-Reference-Cited by-同舟云学术

Comparative Evaluation of the Damping Capacity of As-cast and t6 Temper a 356-sic AMMCS

Published:2022-11-25 Issue: Volume: Page:354-363
ISSN:0022-2755
Container-title:Journal of Mines, Metals and Fuels
language:
Short-container-title:jmmf

Author:

Rajiv T. G.,T. V. Sreerama Reddy ,R. Chandrashekar

Abstract

The paper discusses the response to free vibration and also to forced vibration of the A356-SiC AMMCs in the as-cast and T6 temper conditions for the comparative assessment of the damping capacities. The base A356 aluminium alloy and seven A356-SiC composites with SiC percentage ranging from 2% to 12% were stir cast and cantilever specimens of 180 mm length were tested for their frequency and amplitude responses. From the results obtained, it was concluded that the A356-SiC composites with 8% SiC and 3% SiC in the T6 condition could be favourably considered as candidate materials for diesel engine parts in the automotive industry.

Publisher

Informatics Publishing Limited

Subject

Energy Engineering and Power Technology,Geotechnical Engineering and Engineering Geology,Fuel Technology

Reference7 articles.

1. Mevada H., & Patel D. (2016). Experimental determination of structural damping of different materials. Procedia Engineering, 144, 110–115. https://doi.org/10.1016/j.proeng.2016.05.013

2. Prasad S. D., & Ramakrishna A (2012). Effect of T6 heat treatment on damping characteristics of Al/RHA composites. Bulletin of Materials Science, 35(6), 989–995. https://doi.org/10.1007/s12034-012-0382-7

3. Alaneme K. K., & Fajemisin A. V. (2018). Evaluation of damping behavior of Al-Mg-Si alloy based composites reinforced with steel and graphite and silicon carbide particulate. Engineering Science and Technology, 21, 798–805. https://doi.org/10.1016/j.jestch.2018.05.007

4. Prasad D. D., & Shoba C. (2016). Experimental evaluation onto the damping behavior of Al/SiC/RHA composites. Journal of Materials Research and Technology, 5, 123–130. https://doi.org/10.1016/j.jmrt.2015.08.001

5. Zhang Y, Ma N, Le Y, Li S, & Wang H. (2005). Mechanical properties and damping capacity after grain refinement in A356 alloy. Materials Letters, 59, 2174–2177. https://doi.org/10.1016/j.matlet.2005.02.058