Multiresponse optimisation and process capability analysis of chemical vapour jet machining for the acrylonitrile butadiene styrene polymer: Unveiling the morphology

Abstract

Abstract The implementation of three-dimensional (3D) printing technology has culminated in a notable rise in productivity and operational effectiveness for manufacturers. Additive manufacturing (AM) is a manufacturing technology that implies an alteration from the conventional approach of material removal. The fundamental idea underlying the AM technique is the gradual buildup of layers (layer-on-layer accumulation). In conventional approaches, every component can have detrimental implications due to the direct interaction between the tool and the workpiece, leading to the loss of heat through friction. The utilisation of 3D printing as a way to surpass conventional processing methods signifies a novel development in several sectors. This method involves the utilisation of unconventional techniques for the fabrication of components. The primary objective of this research is to investigate the chemical vapour jet drilling technique specifically applied to acrylonitrile butadiene styrene (ABS) materials. The intent is to enhance the surface characteristics, or surface finish (SF), and the dimensional accuracy (DA) of ABS workpieces. An evaluation regarding the reliability, repeatability, as well as preciseness of the vapour jet drilling (VJD) process is conducted via the utilisation of experiment and data analysis. The study employed a Taguchi L9 design of experiments to carry out a series of tests aimed at analysing the implications of three independent variables: pressure, flow rate, and standoff distance. The researchers employed a multiresponse optimisation approach to attain an optimal combination of parameters that resulted in a superior SF with DA. Consequently, the overall appeal of the outcome was reached. The process’s capabilities and dependability were assessed by conducting tests on the substrates at their optimal settings. Surface roughness and circularity were measured at numerous locations on the substrates. The study determined that the process capability indices (C p and C pk) had values over 1.33 for each of the response parameters, with C pk values also exceeding 1. The analysis of histograms and capability indices demonstrates that the VJD method, when conducted under optimised conditions, may be categorised as statistically controlled for the processing of ABS materials.