Research on the influence of trapezoidal magnetization of bonded magnetic ring on cogging torque-Reference-Cited by-同舟云学术

Research on the influence of trapezoidal magnetization of bonded magnetic ring on cogging torque

Published:2023-01-01 Issue:1 Volume:21 Page:
ISSN:2391-5471
Container-title:Open Physics
language:en
Short-container-title:

Author:

Zhang Ze¹,Wang Zilong¹,Yu Juntao²,Luo Yang³,Yan Wenlong¹,Yang Yuanfei¹,Hu Tengfei¹,Yu Dunbo³,Wang Li²

Affiliation:

1. National Engineering Research Center for Rare Earth, General Research Institute for Nonferrous Metals , Beijing , China

2. School of Mechanical, Electrical & Information Engineering, Shandong University (Weihai) , Weihai , China

3. General Research Institute for Nonferrous Metals , Beijing , China

Abstract

Abstract In this article, the influence of trapezoidal magnetization method on cogging torque of permanent magnet motor is studied. First, the structure is analyzed by analytical method to explain its mechanism of reducing cogging torque. Then, in order to verify the effectiveness of the formula, a six-slot four-pole motor is introduced for finite element analysis. Through comparison of the original structure motor, the magnet skew structure motor, and the trapezoidal magnetic pole structure motor, it demonstrates that the trapezoidal magnetic pole structure motor can effectively reduce the Cogging torque and does not produce additional axial electromagnetic force. Finally, a magnetizing fixture with a trapezoidal magnetic pole structure is made to magnetize the magnetic ring. The magnetized magnetic ring is installed on the motor, and the Cogging torque, Back EMF, etc., are tested. The test results are in good agreement with the simulation results. This method can be used to optimize the cogging torque of the permanent magnet motor.

Publisher

Walter de Gruyter GmbH

Subject

General Physics and Astronomy

Link

https://www.degruyter.com/document/doi/10.1515/phys-2022-0223/pdf

Reference33 articles.

1. Fei W, Luk PCK. A new technique of cogging torque suppression in direct-drive permanent-magnet brushless machines. IEEE Trans Ind Appl. 2010;46(4):1332–40.

2. Dorrell DG, Hsieh MF, Popescu M, Evans L, Staton DA, Grout V. A review of the design issues and techniques for radial-flux brushless surface and internal rare-earth permanent-magnet motors. IEEE Trans Ind Electron. 2011;58(9):3741–57.

3. Hwang SM, Eom JB, Jung YH, Lee DW, Kang BS. Various design techniques to reduce cogging torque by controlling energy variation in permanent magnet motors. IEEE Trans Magn. 2001;37(4):2806–9.

4. Jagiela M, Mendrela EA, Gottipati P. Investigation on a choice of stator slot skew angle in brushless PM machines. Electr Eng. 2013;95(3):209–19.

5. Lukaniszyn M, Jagiela M, Wrobel R. Optimization of permanent magnet shape for minimum cogging torque using a genetic algorithm. IEEE Trans Magn. 2004;40(2):1228–31.