Weld interface metallurgy of dissimilar alloys welded by TIG technique-Reference-Cited by-同舟云学术

Weld interface metallurgy of dissimilar alloys welded by TIG technique

Published:2024-05-22 Issue:7 Volume:66 Page:1010-1018
ISSN:0025-5300
Container-title:Materials Testing
language:en
Short-container-title:

Author:

Teker Tanju¹,Günes Ahmet²

Affiliation:

1. Faculty of Technology , Department of Manufacturing Engineering , Sivas Cumhuriyet University , 58140 Sivas , Türkiye .

2. Hasan Hüseyin Akdoğan Vocational and Technical Anatolian School , Nizip , 27700 Gaziantep , Türkiye

Abstract

Abstract TIG welding is an important joining technique for fabricating quality structural components with industrial capability. Dissimilar alloy plates were combined using double-sided tungsten inert gas (TIG) welding. Microstructure evaluation of joints were anayzed by using scanning electron microscopy, optical microscope, energy dispersion spectrometry, elemental mapping, electron back scatter diffraction. DSAW technique increased joint penetration and reduced distortion of joints. In the weld metal zone, austenite, delta ferrite and lath martensite were dominant. The weld pool had high density of Cr7C3 and Fe3C phases and low density of CrFe7C0.45, FeNi, martensite, and Fe3Ni2 phases.

Publisher

Walter de Gruyter GmbH

Link

https://www.degruyter.com/document/doi/10.1515/mt-2024-0022/pdf

Reference22 articles.

1. R. S. Vidyarthy, A. Kulkarni, and D. K. Dwivedi, “Study of microstructure and mechanical property relationships of A-TIG welded P91–316L dissimilar steel joint,” Mater. Sci. Eng. A., vol. 695, pp. 249–257, 2017, https://doi.org/10.1016/j.msea.2017.04.038.

2. Y. Zhang, J. Huang, Z. Ye, and Z. Cheng, “An investigation on butt joints of Ti6Al4V and 5A06 using MIG/TIG double-side arc welding-brazing,” J. Manuf. Process., vol. 27, pp. 221–225, 2017, https://doi.org/10.1016/j.jmapro.2017.05.010.

3. Y. Miao, X. Xu, B. Wu, X. Li, and D. Han, “Effects of bypass current on the stability of weld pool during double sided arc welding,” J. Mater. Process. Technol., vol. 214, no. 8, pp. 1590–1596, 2014, https://doi.org/10.1016/j.jmatprotec.2014.02.029.

4. K. Kumar, C. S. Kumar, M. Masanta, and S. Pradhan, “A review on TIG welding technology variants and its effect on weld geometry,” Mater. Today Proc., vol. 50, no. 5, pp. 999–1004, 2022, https://doi.org/10.1016/j.matpr.2021.07.308.

5. T. Sakthivel, et al.., “Comparison of creep rupture behaviour of type 316L(N) austenitic stainless steel joints welded by TIG and activated TIG welding processes,” Mater. Sci. Eng. A, vol. 528, nos. 22–23, pp. 6971–6980, 2011, https://doi.org/10.1016/j.msea.2011.05.052.