Author:
Lichańska E.,Sułowski M.,Ciaś A.
Abstract
The effect of chemical composition of the sintering atmosphere on the microstructure and mechanical properties of PM structural low-carbon steels is presented. The base powders were Astaloy CrL, Astaloy CrM, low carbon ferromanganese and graphite C-UF. From the base powders two mixtures with compositions of Fe-3%Mn-(1.5/3%)Cr-(0.2/0.5)%Mo-0.2%C were prepared. Following pressing in a steel rigid die, compacts were sintered at 1250°C for 60 min in a semi-closed container. 5%H2-95%N2mixture and air were the sintering atmospheres. For sintering in air, lumps of ferromanganese were placed with the compacts in the container. After sintering, half of the samples were tempered at 200°C for 60 minutes in air. Mechanical tests (tensile, bend, toughness, hardness) and microstructural investigations were performed.The microstructures of the steels were inhomogeneous, mainly ferritic-bainic. Tempering of steel based on Astaloy CrM sintered in an atmosphere of 5% H2-95% N2slightly reduced tensile strength and toughness: from 748 to 734 MPa and from 7.15 to 6.83 J/cm2, respectively. Chemical composition had a greater effect; steels based on Astaloy CrL and Astaloy CrM had tensile strengths 526-665 and 672-748 MPa, hardness 280-325 and 388-421 HV, respectively. The best properties were obtained after sintering in air of Fe-3%Mn-3%Cr-0.5%Mo-0.2%C without heat treatment: tensile strength 672 MPa, toughness 6.93 J/cm2, hardness 421.1 HV, 0.2 % offset yield strength 395 MPa.
Reference9 articles.
1. Microstructure and mechanical properties of Cr - Mn structural PM steels of and Materials;Sułowski;Archives Metallurgy,2011
2. Dilatometric investigations of Fe - Mn Cr - Mo PM steels with different carbon concentrations Metallurgy Progress;Sułowski;Powder,2008
3. The Microstructure and properties of low - carbon PM Mn Cr - Mo steels sintered under different conditions of and Materials;Sułowski;Archives Metallurgy,2014
4. Microstructure and properties of Cr - Mn alloyed sintered steel Metallurgy Progress;Sułowski;Powder,2012
5. The effects of processing parameters on the structure and mechanical properties of structural PM steels containing Mn Cr and Mo of and Materials;Sułowski;Archives Metallurgy,2014
Cited by
7 articles.
订阅此论文施引文献
订阅此论文施引文献,注册后可以免费订阅5篇论文的施引文献,订阅后可以查看论文全部施引文献